Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

interfacing a cc2500 with AT89s8253

Status
Not open for further replies.
A

apoorvaashok

Newbie level 3
Joined
Mar 31, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
Hi...
Am working on a project which requires wireless communication between 2 microcontrollers-AT89s8253. I have chosen cc 2500 for the same but i need help regarding the circuit and sample codes for the interfacing. Pls guide me on this..

Regards,
Apoorva
 
Last edited:

you didn't say whether the code should be in c or asm.

download swrc021f.zip
https://www.edaboard.com/threads/148209/

read the datasheet of the cc2500.
run the whole circuit at 3V including the 89S8253. You'll want to use the hardware SPI module in the 89S8253.
 
Last edited:
the code will be in c. Thanks a lot for the link... Could u pls guide me a bit regarding the circuit diagram???
 

have you actually looked at the datasheet? there will be a circuit there you can follow.
 

Hey... Ya i did go through the datasheet. The circuit issue is resolved. But I'm in the dark about using Smart RF Studio to obtain the register values. The cc2500 i have is just a chip and the microcontroller board that i'm using does not have a USB interface...

Can i connect the cc2500 to the board and then connect the board to the computer using a suitable RS232 connector?? Will that enable Smart RF Studio to configure it??
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top