Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
there could be some week pull ups/down internally connected to the controller pins.
you can even interface the keypad without any pullups. but when you connect the pull ups. you are sure about the ststus of that pin at certain time and you will not source much current from the controller pins when you make them ground.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
