Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] How can I force solder side in Altium

Status
Not open for further replies.
kororos

kororos

Newbie level 4
Joined
Jan 9, 2011
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,329
Hello,

I am designing a double sided board using Altium and I have managed to fabricate it (at home) without any problem (well aligned etc.). However, what I need to do is to force Altium auto-router to connect the ICs only on one side. Otherwise it is impossible for me to solder them. I do not mind having a few more vias. Does anybody know how to do this in Altium?

Thanks.
 
Last edited:

No way, apparently :sad: Use smd's or set altium rules to route all connections on bottom layer only
 
  • Like
Reactions: kororos

    kororos

    kororos

    Points: 2
    Helpful Answer Positive Rating
Thank you Frigzy. This is a shame :(

I have updated the PCB with interactive routing now (for these ICs).

Thanks again.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top