aredhel
Member level 2
+dxp2004 +1 layer +route
Hello there I started to learn PCB making using DXP 2004 and use **broken link removed** site for a short tutorial. I have a few questions on DXP 2004:
1. How do I view my silkscreen? Somehow I could not find it. Even the "Help" files are giving me problems.
2. Auto-routing: all I have to do is place the components inside the PCB board and then "Auto Route >> All" ... right? All of my components have their own ready-made footprints, so there are no custom footprints in my design.
3. Is it possible to create my PCB using DXP 2004 with only 1 layer, because the auto-routing connection shows red and blue lines. So that is a 2-layered PCB, top and bottom and that kind of PCB board is rather expensive ... around 40 where I come from and I want to cut cost.
Hope someone could help me.
Hello there I started to learn PCB making using DXP 2004 and use **broken link removed** site for a short tutorial. I have a few questions on DXP 2004:
1. How do I view my silkscreen? Somehow I could not find it. Even the "Help" files are giving me problems.
2. Auto-routing: all I have to do is place the components inside the PCB board and then "Auto Route >> All" ... right? All of my components have their own ready-made footprints, so there are no custom footprints in my design.
3. Is it possible to create my PCB using DXP 2004 with only 1 layer, because the auto-routing connection shows red and blue lines. So that is a 2-layered PCB, top and bottom and that kind of PCB board is rather expensive ... around 40 where I come from and I want to cut cost.
Hope someone could help me.