Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] How to opt the shell parameters?

Status
Not open for further replies.
tony_lth

tony_lth

Advanced Member level 5
Joined
Jul 28, 2010
Messages
2,087
Helped
377
Reputation
756
Reaction score
368
Trophy points
1,363
Location
Beijing
Activity points
12,629
Hi, Gurus,
In one TI 77G desgins, it used the following as antennas: 3 TX , 4 RX.
And I simulated the 3 TX antenna's spec as the attachments.
The problem is the TX beamwidth is too samll.
I need to design a shell over all the antennas, the problem is I can opt the shell height over the board and shell thickness for the TX antenna.
Then I can opt the shell height over the board and shell thickness for the RX antenna.
The problem is that the two opt results will be different.
So how should I do? Tradeoff or some other ideas?
Best,
Tony Liu
 

Attachments

  • TI_1843_77G_Antennas.PNG
    TI_1843_77G_Antennas.PNG
    145.7 KB · Views: 93
  • 3TX_Antennas_20220108134043.png
    3TX_Antennas_20220108134043.png
    98.8 KB · Views: 97
  • 3TX_Antennas_20220108134004.png
    3TX_Antennas_20220108134004.png
    133.5 KB · Views: 101

Sort by date Sort by votes
Theoretically, the shell should be very thin and made from a material with low dielectric, to get minimum influence on the radar array pattern. Usually, the RX array may be more affected by the shell because is doing direction of arrival (DoA), when the TX antennas transmit boresight.
If the distance between antennas and the shell is greater than 2λ, there will be less influence on the array antennas (about 8mm at 77GHz).
Sometimes the radar module manufacturers provide the modules with shells in place.
 

    tony_lth

    tony_lth

    Points: 2
    Helpful Answer Positive Rating
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top