Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How To Operate Beacon Receiver ASC 300KUE-T

Status
Not open for further replies.
O

other-side-of-d-moon

Advanced Member level 4
Joined
Oct 18, 2010
Messages
100
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Activity points
1,961
Dear Friends

I brought a beacon receiver (ASC 300KUE-T Brand), i have connected it to LNB but i don't know how to get the signal levels, the software i think is very basic because it only has one window as shown in the link below. Please guide me whither i'm mistaken or not? did i forget something? should i connect other equipment to the receiver to measure the signal?


here is the software window
https://obrazki.elektroda.pl/1680061900_1413095742.jpg

D4EAC801-07A8-47BE-B84D-777FB9B462B9.jpg

This is the receiver specifications
file:///Users/dahonest/Desktop/ASC300KUET.pdf
 
Last edited:

Oscillator frequency in LNB must be known. Frequency window in your software must be filled with difference between beacon frequency and LNB oscillator frequency. When antenna is positioned to satellite you will get DC output (BNC).
 
Thanks alot Borber about your valuable help, in which do you think signal strength will come out?
 

As per datasheet DC is availale on BNC connector and terminal plug.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top