Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

FPGA: Verilog HDL Make a motor spin both directions with variable speed

Status
Not open for further replies.
J

jaycribs

Newbie level 3
Joined
Jan 27, 2012
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,319
Hi i need help the Verilog programming code...im supernew to Xlinx...but i already started my research abt the verilog program...i just really confused about where to start with the code.. My project is Using a Digilent BASYS FPGA board: Make a motor spin both directions
with variable speed that can be set with switches SW0 - SW7. The L298 Hbridge can be used. Care must be taken to protect the FPGA from excessive
current draw and large voltage transients.

Where do i start with writing the verilog code for this project. Thanks Guys
 

You might want to consider using one of Digilent's H-bridge PMOD expansion modules, such as the PMOD-HB5. Even if you don't use it, the manual explains how you need to use PWM to control speed, and there's a complete reference design.

If you want to use an L298, most of the Digilent stuff code will still be applicable, though the interface is a bit different. Read the L298 data sheet and study up on H-bridges in general.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top