Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Snap to in HFSS 11
just read your post... maybe you have solve it
Set the operation data entry mode ---> Point
Please go Tools --> Modeler Options ---> Drawing ---> select the Point entry mode.:D
Re: Motion sensor
Hi all,
U're very helpful :D
thx so much
Added after 7 minutes:
Hi Fragrance,
I'm not thier member, could you please send thier copy to me?
:D:D:D
Hi all,
I'm a new guide in the LTCC design and need to desing a filter using this material recently. I don't know how to de-embed these values using the HFSS. I have try to model the capacitor and de-embed its value, but the value is big different when compare to the general formula i.e...
Dear all,
Can everyone give me some hits to design the RFID baseband. Since it return signal level is very low. However, it will destroy the waveform if the signal amplified too larger. Please give a help to me !!!
Thanks a lot
Hi, all
I also going to design a DRO, and it works on 10 GHz, but I found that where there have no DR, the circuit is also have a resonant frequency, it is ocrrect ? Also, the output power is very low, there only around 4 dBm.
Please help
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
