Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
this is wild guess.. i am not sure of it.
it seems to be you are running the design in functional mode with DC netlist , and if you are running in scan mode in ICC, the frequency used for scan mode operations is different from functional modes and generally it is less.
so this might be causing...
@yx.yang..
yes, we can try it if the chip is manufactured, but at lower frequency, as i feel it will definitely cause setup violations. so to make the chip work at different voltage without setup violations we need to operate at low frequencies.
as you suggested we need library with the voltage...
I don't think we can change the supply voltage( reduce supply voltage) to fix the hold violations, as it affects the total design, which may result in setup violations other points.
i think the circuit should give "0" as output in normal conditions..
and it will give "1" as output when any violations occur.
the functionality of the circuit is
(clk'.data').(clk.data).(clk.data').(clk'data)
this functionality gives output as for any given input,
but when there is any...
i don't know whether i can post the links here o rnot
bu t here is the link for solutions for solid state devices by streetman.
**broken link removed**
cadence ac input impedance
hi for my inductor i had taken 600mv as operating point voltage and 150mv as ac voltage, when i am using the expression VF(V0)/IF(V0). in my case it is V2 not V0. a messge window is coming.
{evaluation error(ERROR:("eval"36 t nil ("Error"eval :unbound...
cadence impedance
hi
i am implementing active inductor in cadence for that i need to plot the input impedance at various frequencies,so help me about what analysis i need to choose and what are the output variables i need to consider...etc.
iam doing simulations in cadence virtuoso.
please help...
temperature controller using atmel 89c51
please help me to design
temperature control of a room with 4 sensors using 89c51
and
audio signal to be fed to LED display with out interfacing 89c51 and that glowa according to amplitude of analog signal
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
