Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I did the test, with red on 2 and black on 1... but I don't have any measurements....?
yet when I disassembled the laser diode it worked...:unsure:
Hi Dana
obviously I did some tests with that circuit you see and everything works correctly...
the question was if with the same digital potentiometer I could connect 9...
could you help me, to identify the right datasheet, based on the abbreviation L96 4G5P that is on the laser diode...
I recovered the diode lasers from an old application, I don't know exactly the mWatt sure below 100...
near the case I can read L96 4G5P, but I can't find the related datasheet...???
Hello everyone,
I wanted an opinion on an idea that came to me ...
I would like to design and build a Wallbox to charge Type1 and Type2 electric cars ... obviously for educational purposes only ...
Given that I am a programmer with experience in programming ATMEL microprocessors, sensors...
Hi,
I made the attached circuit to make an automatic soap dispenser ... it works well except that sometimes when the timed out ends and you take your hand from under the IR sensor the timed out is reactivated ...
some advice? thank you.
ok I will bring the frequency of the NE555 to 40Khz ...
kindly in the scheme you insert "high pass filter with a corner frequency of about 30KHz" in my scheme ... thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
