Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I want to use a 4-wire unshielded and twisted cable of a indoor installation as a transmission system for a usb connection between a PC and several webcams across a house (25 to 40m away). My goal is only use 2 usb hubs (one in the connection to PC and other in a webcam).
I have read that...
I'm trying to use a bt8x8 as a digital oscilloscope. My idea is to "mount" signal over an artificial video sync and decoder later the adquired signal. But my problem is how can i adquire signal from visual c++ , does anybody has source code for adquiring video?
Thanks on advance
Hi,
I'm using a JDM serial programmer variant (TE-20 model) for programming a 18f1320. Other pic chips are well programmed but this one not. I suspect reason could be a low MCLR voltage (between 12 and 12,30V on this programmer).
Some ideas for programming that chip using this programmer? How...
tv card oscilloscope
Is there any way of programming a PCI TV Card with a bt8x8 chip as a digital oscilloscope? I was thinking that by adapting signal levels to tv ones it could be possible in some way...
Thanks in advance.
Hi
I build a te20 programmer for PICs and it was fine for programming 16f84a devices. But by using it with 16f818, i get an error message (" verification failed "). I use ICPROG 1.05A software.
Schematic of TE20 is attached (unfortunally explanations are in spanish)
Thanks on advance.
logic analyzer circuit
I was planning a PC based logic analyzer. The idea is using a cache like sram (like 7cy199 or similar) and storing in it digital samples at high speed (40MHz) for later download to PC via PC port. First experiments demostrate concept is ok, but over 5MHz, strange digital...
tda8703
I was building a PC based oscilloscope based on a parallel port and a tda8703 plus some glue logic. However i was having terrible problems with noise (in form of some spikes).
Hardware is simple. Just a 74als244 connected to parallel port for data in(in epp mode). In one extreme and...
picbasic 16f876
I was thinking in using special analog I/O from 16F876 and a normal hitachi lcd with 2x32 char for having a miniscope, some ideas code for 16f876?
Thanks on advance.
power line communication circuit
I would like to communicate two computer using a 220V powerline. Where I could find schematics or information?
Thanks in advance. 8)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.