Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have a device which sends serial data @ 1gbps using TI's TLK1501 using proprietary poin to point protocol (does not use ethernet frame) just like simple serial protocol. Can I fed this data to Ethernet port of PC with Gigabit network adapter and read it?
How do I read data available at...
[solved]: PC Lint with Keil uVision 4
It was issue of Keil uVision 4.10. The issue has been resolved in ver 4.14 onwards. So upgraded to next ver.
I came to know here : **broken link removed**
Thanks
Hi all,
I am using PC-lint 9.0. When I run PC-lint with Keil uVision 4, it seems its not generating any output or messages. It just shows "Running PC-lint...." I am using example code. See following screen shot:
I have setup Lint as:
Please help. PC-lint works fine with MPLAB. Thnx
Hi, DFT for the app seems better and working also.. :-)
I had tried with goertzel before also.. was not working.. may be i have made some mistake in calculations.. will try it some other time...
anyways thnx
Hi,
I have a comlex waveform which contains harmonics. I am taking 32 samples per cycle. But I am interested only in first five components. I dont need all components for harmonic measurement. How can I optimize FFT in this case.
Thnx,
I need to read it using ADC. So I need to give DC shift of AVCC/2 to it. I am sensing very low magnitude of AC current using resistor whose one end is grounded.
Hi all,
I want to measure 50µV, 50/60Hz AC signal. with gain of say 100, in low cost way also I need to keep supply current of the amplifier below 100uA. I searched precision instrumentation amplifiers but either offset voltage is more or supply current is more. Can I do it with normal opamp...
see caution on the same page:
Caution The absolute maximum ratings are rated values exceeding which the product could suffer physical
damage. These values must therefore not be exceeded under any conditions.
4.2 V lies in range specified electrical specification. So overcharge u can set around...
Hi,
I am measuring voltage across inductor.. which is differentiated .. i.e. LdI/dt.. With frequency di/dt increases linearly. So I want to integrate the measured signal inside DSP. I am new to DSP. Can somebody help me.
I tried using LPF 1st order IIR filter, but not giving me exact results...
mosfet as a switch
Hi IanP,
Actually load is 2 op-amps LMV324. I also tried to put dummy load, but no help!!!
Its still at about 1V.
But if I replace BJT by N channel MOSFET, it works fine......
I am just wondering what would be the reason.
mosfet load switch
Hi all,
I am using MOSFET to switch on/off supply to one section of my circuit. Supply voltage is 3.3V
The circuit is attached here.
When PS_Control is HIGH, I get 3.3V.
But, when PS_Control is low, still I am getting approximately 1V at the output. But i want the voltage...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
