Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hai Kumar,
A temperature inversion is a thin layer of the atmosphere where the normal decrease in temperature with height switches to the temperature increasing with height. An inversion acts like a lid, keeping normal convective overturning of the atmosphere from penetrating through the...
Hai,
First you verify the pins are firmly attached with the base of the programmer.
Selection of com port is important. After selecting the com port select the chip correctly in the options. Then it will show the display ' Device identified '.
Still it is giving the same problem...
Hi,
For Simulation you can connect different antennas lamda/2 apart. But practically
you want to connect many antennas with distance lamda/2 apart, you have to increase the power of the transmitter.
Regards
Sudan
Hai,
ANOTHER SUGGESTION !!!!!!!!!
Plug in your hard disk (not working one) with a Working computer Hard disk as Slave mode and Check. If it is not detecting your hard disk , definitely it may be damaged. If it is detecting your Hard disk partition automatically add with...
Re: infrared robot car having camera using 8051 microcontrol
Hai,
The encoder is HT12E and the decoder is HT12D. Easily you can get correct output.
Regards
Sudan
Hi,
For rotating stepper motor you have to apply pulses. for increasing the speed just reduce the delay of that pulse (through the program).
regards
Sudan
Re: infrared robot car having camera using 8051 microcontrol
Hi,
If you want to use IR , then better to use encoder. the output of encoder is directly give to IR transmitter. Then IR receiver output is given to decoder and the decoder output is given to micro.
Regards
Sudan
Re: which connector is best suited for a 3 wire RS 485 netwo
HI,
Definitely you can connect any other pins than the particular screw type. Audio jacks are minute one. Instead of that you can use any three pins like power supply male and female connectors or any other type you can use...
Hi,
Very simple..... In the button's corresponding "call function" just give the name of the GUI. Thats all.... It will open directly.........
Bye
Sudan
Re: crystal oscillator??
Hi,
I have engaged with some other work. I did't open the site. Any way.......
Now for your problem, You just take the output from the parallel port and give directly to MAX 232 input. The the output of MAX 232 to the Micro. Thats all......
I think you...
Hi,
You are using 4 stepper motors. Based on the number of motors used the power consumption will vary. For seeing this you can connect a ammeter before your circuit serially. It will show the current consumption of your circuit and multiply the value with the supply voltage what you are...
Re: crystal oscillator??
Hi,
Yah, Laptop has no serial ports. You can use USB to serial converters and are available for cheap price. You can use that instead of parallel. It is much suitalbe for you....
Regards
Sudan
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
