Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I m using Airtel SIM and this worked fine at my LAB and Office in Gujarat.. But when transferred the SIM and the device to Bihar it is giving this Error.
I tested for following commands..
AT+CPIN? : Response was +CPIN READY
AT+CREG? : Response was +CREG:0,5 ( this means Registered Roaming)...
hi
Can't give Opto Isolation to my application for separate grounds.. as the application demands to run on Battery as well...
suggest other possible alternatives...
Hello
I am driving a Spark Ignition Circuit from my micro controller using a 12V DC supply thr a Relay.
However when the spark ignition system is powered using this 12V the micro controller sometimes shows erratic behaviour. Tried suppressing this noise using a 0.01 Cap + 100 Ohms Res Snubber...
DS1302 Problem
I have successfully interfaced DS1302 with 8051.
The application demands that at some of time I need to STOP the Clock, wait for 2 to 5 Seconds and then RESTART the CLOCK.
I am trying to do this using CH bit of DS1302. However am unsuccessful. Even though I am appropriately...
8051 and DS1302
I have successfully interface 89C51 + DS1302 + Display + Keypad and a Relay which is driving a solenoid.
Well, the system works fine but sometimes the RTC Time stops intermittently and the clock stops on its own. This peculiar phenomenon occurs especially when I try to actuate...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.