Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi sweetchoto,
I agree with you still meshing is of great importance factor in HFSS, althoug they have a smart algorith for meshing but I think from one simulation to another the deviation seems to be not acceptable. Try to fix your mesh or to use length based meshing on surface, it helps...
Re: Modes in HFSS
Hi tallface65,
Your discusion before was so helpfull.
But when I did the same thing for lower modes( I expect my first mode will appear from say 200MHz) the solution did not converge even when I changed the minimum frequency in the setup to 100MHz.
should we also change...
Re: Higher Modes in HFSS
Hi tallface65,
Your discusion before was so helpfull.
But when I did the same thing for lower modes( I expect my first mode will appear from say 200MHz) the solution did not converge even when I changed the minimum frequency in the setup to 100MHz.
should we also...
Hi all,
My question is about the dispersion diagram for low frequencies, say 200MHz or 300MHz. Although the reflection phase of my unit cell shows a zero phase within these low frequencies but the dispersion diagram dose not coincides with the reflection phase. I mean the first TM mode shows a...
Hi Yash,
I am a new user on HFSS 11. and i am interestig in the same issue.
I will be appreciated if you have a time to answer me how can we adjust the cutplanes(reflection or evalution planes over which we record our fiels) for different angle of incidence (There is no Geometry menue just...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
