Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Tnx Fentrac i downloaded the prgram but i soon found out it mostly works on the parallel port and only 1 usb port and the one usb port didnt reconize mine
so that ended that. The program looks like it would do a nice job sure would be nice if it would work on most usb's. I noticed its last...
Thanks fentrac i'll give it a try i suppose the program is on the web somewhere
another thing i forgot to mention do you need the eeprom data as well when burning to a new chip
Thanks Ray
HI
i have a pic16F628 that i burned out the pin 3 data input used in the 5 digit frequency counter sold on the web i read the chip and it say's that the chip is not protected. i need to program a new chip so i need to get the data from it to burn a new one i am using pic basic pro . when i do...
hi Jay
I just ran mine with the line numbers it came up line46
yours is on line68 but it says maks2 mine is mask 1
how did you get the expanded view ???
I also put a remark statement in front of ((goto ISR) your line 35 but yours
is worded different then it gave me an error on your line59...
Hi
I found this program in the pic basic pro book listed here on this site so I assumed the programs should run ok
but I run across this problem as soon as I typed in compile ISR is not a label . what am I doing wrong
im sure everything is typed in ok and I am using the pic6f628 . I took a...
Jay Im not sure what mikrobasic is but I found a solution . I found that the n array counts from left to right in the lookup statement
so what I did was to reverse the digits order I took the first statement and moved to it to the last and then took the last to the first
I might be confusing...
Hi Jay
did you get my post ???
I had to send it 2 times I hope it went through
I noticed that it went to my original post is that the way its done.?
I thought it would go to your reply
Thanks Ray
Hi
I was looking at a countdown timer sent in by Metal it was quite a way back 05-08-05 the title was countdown from 8 to 0
I like the ease of the program so I downloaded it then ran it
it ran right off no problems EXCEPT it counts up .What I really need is a count down time with a short...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
