Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i have one doubt, is all the lines in electronic circuits are transmission lines or, is the signal wavelength is less than the length of the cable thenonly it becomes transmission line?. what is the condition that the line to become transmission line.
if it is the condition for transmission...
i have one doubt, if all the lines in electronic circuits are transmission lines or, if the signal wavelength is less than the length of the cable then it becomes transmission line.
if it is the case when the signal frequency is less than the length of the line in transmission line then why...
hai,
i have one doubt. while i am doing serial communication using cortex TM4C123G processor, the error comes like that, gmake: *** No rule to make target `C:/ti/ccsv5/eclipse/TIVAWARE_INSTALL/driverlib/ccs/Debug/driverlib.lib', needed by `lab12.out'. please tell the meaning of the error and...
how the direct form is most sensitivity to the coefficient quantization in IIR filter. and cascade form is not much sensitive to the coefficient quantization in IIR filter.
how the direct form is more efficient in FIR filters.
Re: difference between moore and mealy
hi,
i understood what you are telling . i have one doubt.
how the mealy faster than moore.
and for designing of the system which one is more useful.
my doubt is if the system is LTI then only the output is not change even we interchange the order of the system.
here if we sample and quantize or quantize first and sample next will give a same result.
so that means the combination of sampling and quantization is LTI system.
reference:Y...
i have one doubt.
when A and B system are cascade, then if the system is linear time invariant system even A and B are interchanged, no change in result.
quantizer is a nonlinear system. but even the sampling and quantization is interchanged the entire result is unchanged and same result get...
i understood,
but in oppenheim "signals and systems" second edition book page no 522, they are telling that interpolation is commonly used for reconstruction in discrete to continuous time converter
no, i am asking why this reconstruction filter is called interpolation filter?. is this interpolation and interpolation in the multirate signal processing are same or not? please tell.
i have one doubt. what is the difference between interpolation filter in DAC and interpolation in multirate signal processing. why the filter in reconstruction of DAC is called interpolation filter.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
