Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hy,
I am using orcad 16.6.
i know schmetic design in orcad 16.6 but after pcb layout procedure don't knw. so how to generate layout in orcad 16.6. in that pad designer softwer for footprint creation that also dn't knw & how to import directory.
if anybody have a procedure for full orcad...
hy,
I am using orcad 16.6.
i know schmetic design in orcad 16.6 but after pcb layout procedure don't knw. so hoe to generate layout in orcad. in that pad designer softwer for footprint creation that also dn't knw & how to import directory.
anybody have a procedure for full orcad 16.6 then plz...
hy friends,
How to generate CNC Drill File In Protel 99SE software...
I Generated all Gerber file with NC drill File.....But Dn't knw how to generate CNC Drill File.....
Help me PLZ.....
plz consider the code is c2k.................it's not f9...the image is only sample.....i have same component; same package....but it's not f9.....it is c2k........dn't serch f9 code component.........want to c2k code component detail....
i have the same component of SOT-89 Package...but it's smd code on it is NOT F9.......but the code on it is C2k, C13......the component shown in the image is only sample, plz consider the code as C2K, C13......i want the part no of this code (C2K, C13)..
hello friends.....
i have 1 component..& i don't know what is the part no. of it......
SMD code on this component is C2K C13....& it's package is SOT89
it has 3 pins.....& also attached Image file...
if possible then send me the link of datasheet.......
it is used in transducer.......
thank...
hy,
i was completed 1 project in protel99se software.....it's open perfectly.....
but yesterday when i was open this project...it could't be open....& it show new file...i took photo of that error......i attached photo with this comment...
please tell me what should i do.....?
yes, i want to "check both combined circuit dig & layout"......."schematic against your layout". b'coz when we completed project from schematic to pcb layout...then i want to check schematic with layout.....so hw's chek it in protel 99se software...?
hii..
how to check both combined circuit dig & Layout in any softwer..? (Protel 99SE, Orcad 16.3, etc)
AND also tell me eletrical rules for pcb desgn...
am using Protel 99SE for the first time and I have completed the schematic
diagram and created a PBC file with all the appropriate footprints.
The schematic ERC check is OK but when I 'Update PCB.' and press 'Preview
Changes' I get the following errors:
ERRORS: 40 macros can not be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.