Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In reference to previous thread:
https://www.edaboard.com/threads/296190/
I, too, have the same issue. I am not getting any parameters listed in the dialog box. Did you solve the problem? If you have any document explaining the procedure to carry out sensitivity analysis, can you kindly share...
I am getting an almost correct result using eigen mode solver for SRR structure. But the eigen frequency corresponding to first phase value is always incorrect. Did anyone face the problem? Kindly reply.
Hello,
I am trying to reproduce few results from John B. Schneider's lecture notes. I am not getting the fourier transform of ricker wavelet as given in figure 5.1. Instead of getting unit peak amplitude at fp, I am getting 0.4.
has anyone reproduced the result from 5.4(b). It would be really...
I am trying to simulate a waveguide filled with Mu negative material (bulk model: Lorentz model). the resonant frequency is 8.5 GHz and negative permeability extends till 9 GHz. Waveguide has a cutoff of 10 GHz. According to literature, I should be able to get a passband (eventhough its below...
hai....can you post the title of the paper?
---------- Post added at 00:09 ---------- Previous post was at 00:06 ----------
the substrate that you have taken seems to be of higher epsilon value....it will show more dielectric nature....and the metallic inner and outer conductor is given as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.