Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
how to fix dan rewinding the induction motor that we know there is many aplication of induction motor in home or industry in 1 or 3 phase from the name plate?
please help...
(new about induction motor rewinding.:roll:)
i have built it...
the output current 1,5 A,ouput 13,6 V
i want to limit the current only 1 A to rechargeable the lead acid battrey,..
- - - Updated - - -
i have built it...
the output current 1,5 A,ouput 13,6 V
i want to limit the current only 1 A to rechargeable the lead acid battrey,..
my flyback converter I input 3 ,2 A and I output 1 ,5 A,
what cause it???
i using flyback converter conduction continous mode..with f 20 khz..
please help??
i also want to make the feedback to pin 1 to control the output the voltage but i can't....
i want my output 13,8 v.....
- - - Updated - - -
i also want to make the feedback to pin 1 to control the output the voltage but i can't....
i want my output 13,8 v.....
i using the sg 3524 to generated the pwm and to switch the mosfet....
my design...
vin=25 v, and i want to get the output 13,8 volt and the current 0,5 A,...
in datasheet of sg3524,there is formula to get the output that we want...,,, vo=2.5 v r1+r2/ r1...
i have did it,but my output not...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
