Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
LCDPRT EQU P0
;=========BITS ASSIGNMENTS ===============
EN BIT P2.7
RS BIT P2.6
;========RESET SUBROUTINE===============
ORG 00H
JMP INI
;===========...
in our project we have transmitter and receiver ,so watever data is transmitted is received by the receiver and this received data we are sending it to microcontroller we are manipulating it and sending to eeprom ,from eeprom to lcd display .now we are not getting to write code for eeprom part...
i hav written code for lcd intitialisation and display of message which is in the program but m not getting wat changes to make for displaying a message which is stored on eeprom ?help plz
---------- Post added at 05:06 ---------- Previous post was at 05:03 ----------
hav written code in...
can u plz help me v hav designed a ckt n its working fine with one transmitor n one receiver but wen v r using many transmitter for one receiver its not working.
v hav used ht12e encoder and one transmitter module for transmission n at the receiver side v hav one decoder ht12d decoder n...
is it possible to do decoding of data in the microcontroller?v hav encoded the data and transmited it through rf transmitter and at the receiver side the data is received by rf receiver ic and output of receiver is sent to uc is it gng to work?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
