Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I want to find a plastic enclosure manufacturer, that can manufacture a plastic box with opening to USB connector and terminal blocks. Something similar to NI device : NI USB-6008 - 12-Bit, 10 kS/s Low-Cost Multifunction DAQ - National Instruments
Can anyone help me?
Thank you.
What do you mean "one line" ?
About how many caps to use depends on the speed of your device. Usually on digital CMOS/TTL I put 100n and this is enough, some times 1n//100n . Some analog circuits require 10u,,, It all depends on application. Try using caps as it stated in datasheet.
If you want links to VLSI cources, here are some : **broken link removed**
**broken link removed**
**broken link removed**
---------- Post added at 13:55 ---------- Previous post was at 13:54 ----------
What kind of vlsi design, do you want? Analog, Digital, Mixed, RF ?
I need it to be 16bit resolution 8 channels, with USB communication. And as low cost as possible. I saw many ADCs wrom different vendors, but the cheapest and the better parameters that I can find if from Analog Devices AD7689 , does any one have better and cheaper ADC in mind? Also how can I...
Hi ,
I need to design a low cost DAQ system, I need to use 16bit ADC with at least 8 channels.
I found several from Linear, TI, Analog and Maxim.
All of them can easily support 100Ksps, according to their specification they are all the same (plus minus). The only difference is the price. The...
Hi I need to design a DAQ system (for data measurements and acquisition) .
Does anyone can point me on a relevant articles about the consideration for DAQ design.
What should I pay more attention...
Thank you.
Hi ,
I want to use labview in order to write program that will run on PIC(without any RTOS).
Can it be done?
I now that there is Labview embeded, but it will not work with PIC12 or PIC10 (8bit).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.