Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thank you.
it is a three phase e-bike hub BLDC motor ( 36 V , 500W). i need 6 N-channel MOSFET (Half bridge for each phase).
I think MOSFETs with voltage of 60 V and current of 80 A is appropriate. Do you think enough ?
High efficiency is important for me, so i focus on Low Rds Or Low trr Or...
I wanna choose a MOSFET for brushless motor controller ( 36 volt , 15 Amps)
Which is more important in the selection ? (Power MOSFET for BLDC motor controller , about 20KHz PWM frequency)
Low Rds(on)
Low Qtotal (gate charge value)
Low Resistive Switching Times (tr , tf , ton , toff)
Low trr...
can i install Assura (615) 4.12.017 on cadence ic 614.005 ? is it work true ?
if i wanna install cadence ic hotfix 615.511 , i need cadence ic base 615.011 ?
i wanna design and simulate bulk driven ota
Which type of transistors should I choose (for bulk driven mosfets) ? ( pmos2v , pmos2vdsw , ...)
cadence ic
TSMC 180nm pdk
Sometimes I have the following error when trying to create netlist and
start simulation in Affirma Analog Circuit Enviroment:
*Error* fprintf/sprintf: format spec. incompatible with data - nil
After that netlist is not created, Spectre is not starting etc.. I am
using Cadence 5.14 The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
