Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
transformer connected to pumped turbine
Hi everybody,
I want to connect a transformer to a turbine which generate 50MW, which kind of transformer I have to use for this application ?
In an other way, the only think that I know, is that my source generate 50 MW, and I have to use a transformer...
Hi everybody,
I have to make an hybrid analysis for a circuit. The question is : give hybrid equations of the circuit, assuming that capacitors are voltage ports, and inductors are current ports?
could you please explain to me the notion of ports???
thank you
Hi everybody,
I'm beginner in assembly langage, I'm taying to write the behavior of Gated D in assembly langage, but the complilator gives some mistakes, could you please correct me, my code is below:
here is some indications (w0:input, w1: clock, w0: output)
btss w1,#0
mov w0,0xc04
bra there...
Hi, thank you so much, you gave me new ideas
- - - Updated - - -
I considered all informations that you gave me, I reversed the diode, and I tooked a NMOS transistor (power_Mbreak on pspice), I changed the value of some resistances as BradtheRad told me.
In the set of specifications, I must...
Hi all,
I'm working on a buck-boost converter (DC/DC), the specifications are: for 0.5V in the input I must have 3v in the output, and for the amplitude of oscillations that excite the grid of the transistor NMOS it must be less than 3v (the output voltage).
My problem is that when I give to the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.