Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi I am looking for a microstrip stub which is dc short and open at the fundamental and 2nd harmonic? The BW should be more than 20% around fundamental and the 2nd harmonic. Any filter structure is also ok provided is dc shorted at one of the ends.
A wideband microstrip stub (short at dc, open at the fund and 2nd harmonic). BW >20%
How to implement a wideband microstrip stub which is short at dc and open at the fundamental and 2nd harmonic?BW > 20% around the fund and 2nd harm?
Hi I am looking for a microstrip stub which is dc short and...
Thanks for your inputs. When you say "The spacing and widths of the lines generally need to be set at values that will achieve the desired impedance and not necesarily "as close as possible".". I can imagine the impedance would depend on the width but will the spacing of the floating strips have...
Hi all,
I have couple of questions regarding slow wave line and simulating them in EM simulators.
From most papers I understand that the floating strips are always kept as near as possible.
I want to simulate the following in HFSS or sonnet or momentum:
1. A grounded CPW structure and would...
Hello biff44...Thanks for the papers..if i find some script I shall post it here.........in the meantime if somebody still have something please keep posting....
hi cnm...thanks for your reply. Actually I got the general methodology from some publication. But the thing is there are some huge equations that i need to solve. In my case i have the differential s params and i need the single ended parameters.I am newbie to matlab so if you have some kind of...
Hello all,
I am looking for some script(matlab or any other) for mixed mode to single ended s parameter conversion. The conversion is from differential 2 port(mixed mode) to single ended 4 port.
I hope to hear from someone on this asap.
Thanks
Neel
Hello all,
I am looking for some script(matlab or any other) for differential to single ended s parameter conversion. The conversion is from differential 2 port (mixed mode) to single ended 4 port. Also some easier option available in ADS is also fine by me.
I hope to hear from someone on...
Hello all,
I am looking for some script(matlab or any other) for differential to single ended s parameter conversion. The conversion is from differential 2 port to single ended 4 port.
I hope to hear from someone on this.
Thanks
Neel
Hello all,
I am looking for some script(matlab or any other) for differential to single ended s parameter conversion. The conversion is from differential 2 port to single ended 4 port.
I hope to hear from someone on this.
Thanks
Neel
Hello All,
I am bit confused with certain aspects of HFSS simulation for differential structures. So if somebodz can kindly advice me on this.
My scenario is as follows and I explain th esteps I am taking:
My structure is on-chip (1:1) transformer and the feed lines for the transformer...
Hello all,
I have noticed a strange thing during cadence simulation and the case is very simple.
The schematic is a 50 ohm source(i.e. port from analogLib) driving a 50 ohm load. IF I do a pss simulation and check the power at the port it is same as the input power that I put in the load...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
