Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for answering,
I was using mikroC 6.0 and after i got this error, i upgraded it to 6.5 but still nothing. Error code was 0x0010C0 if that mean anything to You. I still didn't test it on real hardware, i just run it in mikroC and proteus. Should this program work in real hardware, because...
You have everything explained in the link below. If you want to read files from SD card that you created on your PC, you will also need knowledge of the FAT table described in the second link.
https://www.win.tue.nl/~aeb/linux/fs/fat/fat-1.html
I am making some code, where i read some files from SD card and analyse it. After some programming when i start debugger it says PC out of scope. When i delete for loop in line 480 it work well, but obviously i need it there. In attachment is whole project. What is the reason this error pops...
Needed schematic for Labview DAQ card
Like i sad in title, i need schematic for Labview DAQ card that has outputs and inputs (for example NI USB-6008). I know its very expensive but i hope i can find any schematic at least some clone that can work with Labview, because i dont have money to buy...
I don't have oscilloscope, but i think it runs, because when i press button on PICKIT2 and than plug in USB red light is blinking and that is a part of PIC to do, and it could not run if oscillator isn't running. I put crystal closest to PIC as passable and caps are 22pf and they are close to...
I hate when this happens.
So still nothing. Now i checked every single wire from gnd on whole board, its ok, i checked all +5V from usb all ok, i checked +D and -D on pic, its good and thay are 1cm long on PCB, crystal is 20Mhz, VUSB capacitors voltage between caps pins is 3V, i checked usb...
Can you tell me what are all the features that can couse USB to fail. I just checked again, and usb is connected fine.
- - - Updated - - -
I also notice that after some time yellow LED lights up, and on pin V_TGT_P its 25pin it shows 3V. Is that normal?
I make PICKIT2 clone that support 3.3V and 5V. Problem is when i connect it to PC Windows does not recognize it. I check USB connection, all 4 tracks are good. I checked capacitor that i found its important for USB at VUSB 14pin, its good, and its 220n. I installed PICKIT2 software (without...
Becouse only way i know to do that, when i dont know voltage, becouse it will be from 20 to 100V, is on that principe of that schematic.
And second i allready used pin for PWM on PIC and i have that pic :)
I am sorry i wasnt clear enough. I have big circuit, and i wanted to implement this circuit in it. There is H bridge actually and H bridge goes through resistor of 0.1ohm to ground. My question is if i use PWM on gates will this circuit on picture do the job to controll current eaven if it is...
I started some project, and i wonder how to controll current when it isnt a clear DC voltage, it is PWM since i control motor and i use PID regulation. Can this circuit do the work or it must be modified and how to modified it? Ofcourse i send L741 output to and gate with PWM i have and than...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
