Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I need help with ADS. I was trying to simulate a simple problem using ADS simulator which is "calculation of scattering from a PEC cylinder". I know this problem is present in literature and solved analytically but I need to solve it using ADS.
Does anyone know if ADS can solve this...
If epsilon is pure real then all frequencies should reflect similarly. I don't know much about your example but may be there was sigma in the dielectric.
Dear all,
I have a simple problem in HFSS which is that I cannot get the reflection coefficient from dielectric correctly on 30 GHz-->35 GHz frequency range. I have 2 layers, one of them is of relative permittivity 15 and the other layer is air. If a plane wave is incident from air region to...
Dear All,
Please I need a Matlab code in Conformal FDTD. That 's for simulating a 2D dielectric cylinder. If you have a code then great if you know where I can find it I will be so grateful too
Thanks in advance
Dear all,
Hope u r fine. I just wanted to ask about XFDTD 6.3 if I can make a 2 dimensional scattering simulation on it or not? I noticed that it has a 2D button which when pressed a 2D window shows up but this window is not interactive except for drawing some shapes...I'm never able to...
Does the arc length increase with r? This is the point which I object about as what you get in the line(delr*delphi) is not the arclength except for the innermost ring of variables only...when you increase the radius (i.e. calculate at a further ring from the center point) the arc length should...
Hi Alperuslu,
What I understand from your code is that your code is 2D code for a cylinder and you create a wave from space position 100,100 :
1-When you defined delr and defined delphi you defined 2 different values for dimensions so you should care about how to calculate the unified time step...
Dear all,
I'm facing a problem with CST microstripes...Every time I run the TLM solver, the following error prevents me from getting the scattering parameters...
Error Number 921:Initial modes are used to establish a mode profile to launch into a port. The mode profile is calculated using...
Dear all,
I need to get reflection (Gamma) for a plane wave incident on a half-space dielectric...This is needed for a broadband so transient analysis is the best way to do it...I ran the simulation but no result related to reflection is obtained in 1-D or 2 or 3-D results....Any ideas?
A CST question: How can I use time domain solver to get S11 frequency response? I read in the manual that we can do that by Transient Simulator "Broadband calculation of S-parameters from one single calculation run by applying DFT’s to time signals" but i don't understand what does that mean...
I mean here that there must be some other way to add ports which excite this sample...these ports should be able to capture S11 (or let's say reflection) from this half-space dielectric...in my case it is multilayered...does anyone here know how to do that?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
