Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
MATLAB AND TMSC6713
salam!!
i need to check my output from c6713 on the oscilloscope.i make bpsk model in simulink and run it on c6713 but i confused how to check signal on oscillscope?
labview help 2009
hello!!
i ve got to know wt was the problem.i did not install dsp module kit.so that y it was showing me error.
if some one know how to use labview for targeting c6713 than let me know.
Re: MATLAB AND TMSC6713
Salam!!
i m using Texas instrument processor c6713 for my project.and m using ccs3.1.i had made simple bpsk model in simulink window ,using matlab 7.5.it shows target file for ccs 3.1 that is needed to load c codes.bt as i know ccs3.1 is compatible with matlab 7.3 or...
matlab and dsp cards
hello?
i m getting thiz error,
while building the program, even though this header file is included in the project. No error occur, when compiled.
while i m runnig simple square wave program in ccs3.1.
c6713 guidance
hello?
i m getting thiz error,
while building the program, even though this header file is included in the project. No error occur, when compiled.
while i m runnig simple square wave program in ccs3.1.
c6713 guidance
hello!1
fatal error: could not open source file "dsk6713.h"
although it is showing it in include library.i m getting thz error while working with code composer studio 3,1
source file dsk6713.h
salam!!
how r u?
fatal error: could not open source file "dsk6713.h"
although i ve uplaoded that file.bt it is not executing it.any budy can tell me?
could not open source file dsk dsp
fatal error: could not open source file "tmwtypes.h
1 fatal error detected in the compilation of "rt_nonfinite.c".
i m getting thz error while runig simulink model using ccs3.1.
can any body tell me?
matlab 2009 is compatible with the ccs 3.1
hello!!
fatal error: could not open source file "tmwtypes.h
1 fatal error detected in the compilation of "MW_c6xxx_csl.c
i m getting thz error while runnig model in matlab simulink with ccs 3.1
help in CCS+TMS320C6713
salam!!
fatal error: could not open source file "tmwtypes.h
1 fatal error detected in the compilation of "MW_c6xxx_csl.c
i m getting thz error while working on matalb simulink +ccs3.1
any budy can tell me?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.