Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi There,
I have a circuit board with 9 loads (assume resistors) and each load is connecting to the input source (Sinusoidal signal) via toggle switch. so, now I've got 9 toggle switch to switch on/off
the loads. The problem is now I want to extend the number of loads to be 16 or 32 etc.. and...
Hi There,
I am working on a design requires small button batteries due to space restriction. So,
Required voltage = 3.6V - 5.5V
retainer or holder Diameter = 8 mm maximum (SMT footprint)
height = 6 mm maximum
I don't mind using stack of batteries if they satisfy the criteria above
Thanks
-MRN
Hi There,
I have a Voltage comparator ADCMP600 and I am trying to set the threshold (reference) voltage to 20mV and this can be achieved by connecting 20mV to pin 4 (Inverting analog input).
My question is how to get 20mV from 3V voltage supply. I know the obvious solution is voltage divider...
Hi,
I am working on an ECG circuit.
It contains an instrumentation amplifier, two high pass filters, an amplifier and pull up resistor.
Initially, I had the pull up resistor after the amplifier and it worked.
I came today to test the circuit and it didn't work so I put the pull up resistor...
Thanks for your response,
But I am still confused about something. In the datasheet there is circuit example (Figure 1. Regenerative Feedback—High-Speed Receiver with 50Ω Input and Output Termination). This example has VT = -2V. Is VT here the Threshold voltage ? and if yes does it mean if I...
Hi Guys,
I am trying to use voltage comparator MAX9691 in my design. Basically the input signal is sinusoidal with peak of 200mV. So, I want to wire up this comparator in order to detect the pulse when it exceeds 20mV. The IC is 8-pins and very simple but I don't know how to set the reference...
Hi There,
Please help me, I just added polygon on a certain area on the board and suddenly some tracks somewhere completely away from I poured that polygon
went crazy and giving me error because of the track width. Also I tried to delete the track width rule and could not delete it. I tried to...
Hi Guys,
Thanks for the quick response,
I am relatively new to Altium and didn't know that there is no need to pour polygons on planes :)
Cheers,
Mourad
Hi There,
I am designing 4-Layer PCB on Altium and having hard time in pouring polygon. Simply I have two internal planes for Vcc and GND and I want to pour polygons on each of them with the right net. But when I try to choose the right Layer which the polygon will be poured on I can not find...
Hi Crutschow,
Thanks for your reply
It is an analogue Sine wave. I can not really find any comparator with this high speed.
Do you know any comparator with this speed or response/delay time ?
Cheers,
Mourad
Hi There,
I am really confused between two parameters in the comparator. The Propagation delay and the Response time.
I understand that the Propagation delay is the delay from input to output of a digital gate switch and the Response time is how quickly a comparator changes output based on an...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
