Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
differnce between any microcontroller & arm
Hello,
I have a silly question (for most of experts):
What is the difference between an ARM(7 or more) and an Microcontroller?
Thanks for your replies.
Mehdi
Hi psmon,
You should pay attention to the fact that adding big capacitor on Vtune will have an impact on the loop filter and stability...
Regards.
Mehdi
Hi,
As explained by lordsathish, you can use IC555. There are plenty of application on the web. Just browse google. Do you have any constraints in terms of current capability?
Meihdi.
Re: communication
Hello All,
depending on the selectivity you want, but you can simply use in parallel to your circuit output a serial L and C (f=1/(2Π√(LC)).That should ground your specific frequency.
What is your working frequency band?
Meihdi
Re: Stability
Hello,
I do not know Hspice but for sure to study the stabilty of your system, you need to break the loop and simulate the open loop transfer response of your system.
Plot the bode diagrams (gain and phase) to get the phase margin and gain margin to see whether your system is...
Re: Divider by 2
Hi the_edge,
I am Newbie in electronics.
I think my previous post was not really clear. Please let me clarify.
In fact, I would like to divide the frequency of an input signal using a flip-flop based divider by 2. I would have expected that one D flip-flop is not enough. So I...
Hello All,
I have questions about the flip flop based divider by 2. There are two D flip-flop.
Is one D flip-flop not enough? What is the purpose of the second flip-flop?
Thanks for your help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.