Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I imported the model into the schematic, I renamed the component to FDT434P, but when I tried to run the project, it didn't work, because it didn't find the model.
Hi,
I have to do a simulation in LTSpice, and unfortunately I don't have a simulation model for FDT434P.
On the fairchild web page there is a simulation model, but it was the extension .mod
https://www.fairchildsemi.com/pf/FD/FDT434P.html
Could you help me please with a simulation model for...
I started to write the software for the transmitter board, but unfortunately it doesn't work.
Could you help me please to fix it?
Please find attached my C code:
#include <htc.h>
#include <pic.h>
#include <picrf675f.h>
// Internal registers configuration
/* Data Memory Code Protection...
Hi,
Could you help me please with an example of C code for rfPIC12F675?
It is my first RF application.
The application is going to work at 433MHZ, ASK mode.
Thank you.
Hi,
I am pretty new in the RF domain. The topic of my actual project is to design a remote control working at 433MHz. I made the schematics, and now I have to do the layout. The problem is, that I have to integrate the antenna in the PCB. I saw some examples of loop antenna on the PCB, but for...
Hi,
I have to develop a wireless remote control on 433Mhz. There are some mechanical requirements regarding the dimensions of the PCB, it should be similar with a car remote door opener.
The power supply is a coin battery of 3V, type CR2032. It has 3 buttons with which it can control 3...
I have no information about the gate weight at this moment. The gate is intended to open horizontally. From the information that I have the actuator will be connected with screws to the gate, and the control ECU will be put on one of the gate's pillar. It will be a RF system on 433Mhz...
Hi,
here is the type of the linear actuator that I intend to use for a gate opener application:
https://uk.rs-online.com/web/p/electric-linear-actuators/7643474/
First of all, is it ok? Or do you suggest me something else?
Thank you.
Hi,
I have to drive a linear actuator on my project wit a PIC18F2620.
I have never worked with motors.
Could you give me please some pieces of advise how to control it?
Thank you.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
