Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I faced this error many times during installation of many programs. when I used ./configure, configuration fails and the following messege appears:
" C compiler cannot create executables "
so please anyone has an idea about this error?
I tried to install ruby 1.8.4 and I followed the instruction in readme file.
I typed the following: ./configure
then the following message resulted:
"
[root@mabdelmawla ruby-1.8.4]# ./configure
checking build system type... ./config.guess: unable to guess system type
This script, last modified...
to: salma ali bakr
no, we don't have the same range of adresses. and I'm forced to use the router as there is someone with me under my router. and he is using a Wi-Fi connection. would you please explain to me how to redirect packets from my interface to the other interface?
and one more...
you didn't get the problem in the 1st place.
we are sharing an ADSL line connection. and all my friends are under the same router. and I'm connected to this router through another router. so thier connection is the WAN connection of my router. and I'm connected to LAN connection of my router...
I'm in the same network with my friends. but I'm connected to the network through router. and I need to share files with my friends. so how can I do that?
Re: LED control circuit help
Yes, I ment debouncing circuit
and about the limiting resistor. I don't think you need them. but chech first from the datasheet of 4017 the output resistor and the maximum sourcing current for output nodes.
but I tried it befor without limiting resistor, and it...
Re: LED control circuit help
connect Q1 of 4017 to the (+) terminal of the 1st and 2nd LEDs and the (-) terminal to the GND.
connect Q2 of 4017 to (+) terminal of the 3rd LED and (-) terminal to the GND
connect Q3 of 4017 to (Reset) of 4017.
connect your Push button to the gnd and CK of 4017...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.