Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Klaus,
Thanks for replying. Your comments helped me a lot! I tested today and got some results in accordance with your inference. Frist the oscilloscope I used only has 20mv minimum detecting gap. And when the input voltage is low (100mv), the waveform displaying on the screen will have...
Hi stenzer,
Thanks for replying. I used both a 1.6 V battery and a signal generator to create DC inputs. They showed the same results. And I checked the FPGA three GPIOs by the ILA. There is no data lost during ADC and FPGA communication with 1 MHZ tsck (The first row is CS. The second row is...
Hi,
Thanks for the good suggestions!! I will do a PCB design for it following recommendations carefully and test it further. Once I got some results, I will post them here.
BR,
LONGGANG
Hi,
Thanks for replying. The ADC right now is not built in a PCB but a breadboard for fast testing like that: This circuit followed the bypassing recommendations in the datasheet. For the ground traces, I thought this will not affect DC voltage inputs. The references are measured by both a...
Hi,
I used a signal generator with 50ohm output impedance connecting with A_in. And for A_in I used both a multimeter and an ocliliscope to read the DC input value as references. A_in input impedance is around 1.3Mohm measured by a multimeter.
BR,
LONGGANG
Hi, I am new to the ADC application. I am using the ADC LTC2314-14 for testing DC inputs and AC inputs. The outside circuit is shown in the figure. For the SPI protocol, there are no issues inside the communication. The FPGA can read the correct SDO from the ADC, the SCK is 1MHZ which is also...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.