Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, I'm using IRF840 mosfets and I need gate drivers for them. The project is an inverter so I found IR2101. Can IR2101 drive them? Do you any other suggestions? Thank you.
IRF840: http://www.datasheetcatalog.org/datasheet/fairchild/IRF840.pdf
IR2101...
Hello. I have to desing and build for my last semester an active harmonic filter. I have desinged it in simulation and now I'm trying to make what happen in simulation real. So here is the problem. Basically many problems. I 've managed to build the control circuit. The basic concept is this: A...
The inverter that I'm going to built will be supplied 320VDC. For load I will use a resistor, and has to create a current reference (Iref). That's it. So I don't need to drive voltages> 600. So will this drive suits me?
Hello
I am using a current transducer for measure current from a pc. The pc's current is a about 0,5 A. So I use a current to voltage converter with op amp to turn current into voltage. But my controller needs only positive signals so I have to add a dc offset to my signal. I have the circuit...
Hello guys. I have a question. I have a project for my last semester. A part of this project is to build an inverter. The problem is that i don't know what gate drivers should i use for IRG4PH50UD IGBTs. Do you have any suggestions? Can you help me please...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
