Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sequence in system verilog
Hi there,
I have some trouble in understanding the working of sequence endsequence in system verilog. Please explain me about the sequence part. What is that ## operator meant for? and what if i change the values???
Thanks in advance...
module sequence_test()...
I faced the same problem... This could be done with one UART port itself. Use a relay. Made the connection like below.
Connect the Tx of GPS& GSM to Rx of the micro controller through a relay.
connect the Rx of GSM to Tx of the micro controller.
By switching between the Tx pins of GPS and GSM...
Hi there,
I am doing my project in vehicle tracking, which uses gps and gsm. I am using pic16f877a(MPLab HItech C compiler). I have completed the codings for both gsm and gps seperately. I need to integrate these things to vehicle tracking. But the pic16f877a has one UART port. Hence...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
