Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your reply. I read the manual and tried all kind of combinations but without any results. However, I just discovered that it is possible to sweep parameters in the monte carlo GUI setup, which makes my simulations a little less dependent on me :-)
Janni
Hello
I am working on a ocean script for a monte carlo simulation.
I am simulating an comparator and the output is either high or low. I want to get the hisogram data from the monte carlo simulation in a vector to wrtie to a database. Everything works, but not the histogram data.
Any...
Hello
I am currently working on a 8-bit ADC. So far i chose the current steering DAC due to low mismatch gradient. During my transient simulations I just disvovered that the converter struggels as the output passes 1 V. The supply is single supply at 3.6 V and the input range is specified to be...
Hello
I am studying integrators and just found the switched capacitor integrator. I saw, that the switched capacitor, C1, acts as a resistor with the value of 1/fC1.
The time constant is then fC1/C2, where C2 is the feedback capacitor.
Just to be sure: The time constant changes as a function...
I made a PWM and a triangle generator to control it. I would like to see the phasenoise of the output signal.
I tried PSS + Pnoise, but i get an error saying:
ERROR (CMI-2208): `V4' is a periodic input signal, which is inconsistent with autonomous circuits.
V4 is a reset pulse with the...
I thought that maybe the gain was too high to find a point in the middle . The sweep response looks as I expected but it tilts no matter how close i get to the point in the middle
I also tried with the inductor but the phase response is the same and starts at -180 degrees as seen on the figure...
I have a problem with an open loop simulation.
I have a resistive load of 10 Kohm and a capacitive of 1pF. Usually I just insert a DC offset voltage source at one of the input terminals, run a DC sweep and chose the offset value to be where the output voltage is in the middle.
This time I can...
Hi!
I am doing a class AB common source output amplifier with a folded cascode gain stage. The load is 1pF and 10 kHz. supply is 0-5V. the gain is > 70 dB
Everything was working as expexted until I changed the DC voltage of the load.
When loads are grounded the phase and gain are as I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
