Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
"The register "RNTI_type" has the property IOB=TRUE, but was not packed into the ILOGIC component."
this warning appear with me in the mapping, I dont know what is the problem.
hint: "RNTI_type" is defined as output register and this is its def
output reg [6:0]RNTI_type,
please reply ASAP...
Hello
addrs is 5 bits
case (addrs)
5'h10: statement; //case 1
5'h11: statement; //case 2
5'h12: statement; //case 3
5'h20: statement; //case 4
default: statement;
endcase
In cases(2,3), the MSB is dontcare, can I select only the first 4 bits withen the same case statement?
Thanks in...
Hello,
I want to design a led matrix with dimention (40m X 50cm), what is the most appropriate (led inbetween distance ) i.e the distance between each led and its neighbour for limiting the number of leds.
the used led has (5mm led)
Thanks tpetar for your help.
I have two question.
1- this error appeared with me : program verify error @address 003D
Data read = 80
Prog data =90
2- Is it preferred to add (74HC541) between the uc...
please I need an Atmel Programmer circuit.
I tried this circuit but it didn't work.
**broken link removed**
Now, I am trying this
https://www.coolcircuit.com/project/atmel_isp/cir1.gif
Is the last circuit is right or no.
Thanks in advance.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.