Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks my friend but this is not what i need , i will till you about the situation
i have a 89xxx usb programmer but you can only read the chip and save file as . bin not .hex , so that i need to convert .bin to .hex
so if there is a possible way to do that
and for the other programmer ??
another question please , refer to this image ( serial programmer ) for atmel family 89xxx if i need only to use ZIF 40 pin only not ZIF 20 ( i don't need any 20 pin controller ) which components should i remove it from this circuit .
i;e : i mean i need only to...
please can any one told me how to reduce these unconnected lines
i have a lot of unconnected lines
i need only single PCB
https://obrazki.elektroda.pl/9357756800_1376300650.png
- - - Updated - - -
another question please , refer to this image ( serial programmer ) for atmel family 89xxx...
dear all ,
i have a big issue , i made circuit using 8051 to control 3 phase AC (380Volt) motor speed using firing angle
it's worked well , but the problem is the motor speed is changed by control firing angle which control also voltage , but in this case the motor become very hot after 4...
I find s suitable Programmer using serial port for AT89Sxx
all i need is all of your opinion about this programmer if any one did it before without any problems
i think there is a missing ceramic capacitor on 89Sxx chip on crystal
so any suggestions...
just one thing , i have already find the target GSM module on Ebay , and i live in Egypt
My friend told me that they will not permit this module to pass in Customs at the airport , so is it right ??
that's mean if i pay to ebay i will not receive the module :(
okay for this programmer how can i download the hex file on atmega8 , i need another programmer for it or just connect atmega8 to usb and download the firmware
https://www.8051projects.info/resources/usb-8051-avr-programmer.23/
thanks
dear all ,
i found on internet a lot of 8051 programmers , i need a simple programmer using serial port not parallel port
just using the MAX232 and the main micro controller i need to program only 89s52 or 89s51 not any C family .
also i found some programmers using another chip with internal...
Thanks bigdogguru
can you please check this one and tell me if it's suitable to interface it with 8051 and send AT commands .
**broken link removed**
can you please check also this one it's cheap than the other one , if it is also suitable for me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.