Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Braski, thanks for the help. However, I didnt see the instructions mentioning about having figures and tables at the end of the document.
the instructions are here: https://www.springer.com/engineering/circuits+%26+systems/journal/10470?print_view=true&detailsPage=pltci_1060487
The...
Does anybody here has sample journal layout for springer? Please help me.
Im planning to publish in Analog Integrated Circuits and Signal Processing.
The instructions in springer for their journal template is really so confusing.I tried the provided template but all I can see are new buttons...
Hi,
I will be starting a project which is a PID controlled single phase BLDC. I have never done motor control before.
I am thinking perhaps modelling the driver though simulink is a good start. However, it has been quite a long time since I used simulink.
Does anyone have any advices on how...
Emulation (i.e implementing it on fpga) is important for you to consider non ideal effects that are not covered by your simulation. Particularly the noise present in your system. Basically it will help you gauge how robust your system is.
Hi,
The techfile from my foundry is *.asc. However, Cadence 6.1.3.1 version cannot see *.asc files. It can only see *.tf file. How can I load *.asc techfile in this version?
Also, I was using an older version of cadence virtuoso and it can see *.asc files whenever I select the techfile. Its...
Hi
Attchde in this file is an image showing an H-bridge circuit with a brushless DC motor load. It can be see nthat the Hbridge is driven by a non-overlapping control signals. Shown on the lower part pf the circuit is the waveforms for the current and the motor drive voltage (O1-O2) I just...
Hi
Attached are two simple types of bandgaps. I just want to ask what is the problem with bandgap A why books have to come up with bandgap B?
I know as I read the books that bandgap A has problems with the opamp's offset and resistors dependency on temperature, but I just dont understand how...
I really have difficulties to produce 1.2V Vref out of the Razavi Bandgap with Vdd=5V Figure 11.9 at sec. 11.3 . Is there anyone who had the same experience?
But if I use the figure 11.39 of razavi. I can easily produce 1.2V.
But it was mentioned that this circuit is for low voltage supply...
Re: Effects of vdd ang gnd bonding wire L on a differential
Hi Mr Freebird
Thank you for your explanation, however, I still cant explain based on my results.
So I attached my results below. I simulated 2 cases, first one with less Vdd and Gnd parasitic inductance, and the othe rone with more...
Hi
I wanna ask if how the parasitic inductance of a bonding wire in the Vdd and Gnd pins affect the performance of a differential circuit structure especially on the differential output. I actually simulated a differential transmitter (LVDS) and tried to put parasitic L on vdd and gnd rails. I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
