Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
calculate antenna gain
If i know the eirp of the spot in my location and i have the received power(dBuV) and c/n measured by the satellite meter how can i calculate the gain of the antenna?
I`v searched by the net for over a week and all i can find are calculation indicated by ham operators...
auto electrical wiring
Hello
Anybody knows a software witch can draw a schematic for a car electrical system but the schematic must have the lines identical with the color of the wire eg. black+white red+yellow
etc
Something like this
Thank you
Anybody has a schematic of any of this switches?
Looks like they work from one producer from another.
e.g. you can change one made by landi with one made by brc even if you have a landi system.
Mine has 4 leds for level of gas in the tank and a swich with 3 posisions one for lpg one for none...
hyundai receiver ics
they came from an satelit receiver and you can see the receiver on the page above.
the receiver is from the romanian digi package and is a hyundai receiver.
35v from the transformer became after been rectified around 48 volts ; (35x1,41)-1,2 = 48
at this voltage the tda will blow up
for 4ohm drivers use a 2x25v transformer and for 8 ohm use a 2x28v trasformer
the tda need around 2 amps so for a stereo version a 150w toroid is enaught
hameg hm205-3 hack
Yes i do :oops: more then ever
later edit...
looks like the forum from hameg dissapear..i want to thank them for the manual.......they uploaded de english version of the hameg 205-3 osciloscope user manual...and much more other equipment :!:
the link is here if anybody is...
unknown chips.if anybody have a clue
**broken link removed**
the lnbp14 is lnb power suply
the wm8726 is for audio
P46AB ?
4580M?
A34?
HC14?
thank you for your time
exactly the same problem here.the relay fails to open/close and the horizontal dimension is small.if you kick start the relayall going back to normal
i suspect a bad weld on the relay contacts.
if you discover anything else please inform me too.
thank you in advance
hameg hm 205-3 bedienungsanleitung
what is so hard to understand?
they didnt have the scaned version and they will not scan it for me,for you or for other person.
why in the last 3 post i have to give you explination about why i cn`t have it?
i have tried all methods...the help from someone...
hm 205-3 manual
they said that the english pdv version is not available...even the german version was uploaded on their site a month ago.
strange firm.....very good products but a lack of otions for them :(
but there is an english hard copy...and hopefuly someoane had scan it.
i hope:(
hm 205-3
i did it already with a pm(no unnececery posts on electroda) but thanks anyway
i also found on their site :) dooh
http://www.hameg.com/en/support/downloads/dl.php?dateiname=HM205-3_deutsch.pdf&datei=man/HM205-3_deutsch.pdf
but its in german :(
anyone with any 205 model manual...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
