Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by geoengineering

  1. G

    [AVR] I have pressing need for the driving CS5532ASZ

    thank you so much for helpful files
  2. G

    [AVR] I have pressing need for the driving CS5532ASZ

    Thank you for your link. but in this site i not VIP member for Download code. Is it possible send me helpful files. thanks
  3. G

    [AVR] I have pressing need for the driving CS5532ASZ

    compiler is CodeVision and microcontroler is atmega32 and I not selected clock frequency. I do not know how to do it. please tell me for header file and c code in this A/D for reading analog signal .
  4. G

    [General] Circuit for pulse generation

    at first, Thanks very much for your guidance and attention I have a few questions about this circuit: 1- How can calculate the value of the output voltage? 2- I need a voltage of about 12 volts and current of about 2000mA That should be changed: [0-12] and [0-2000] 3- Please Explain more, about...
  5. G

    [AVR] I have pressing need for the driving CS5532ASZ

    First,Thank you for your attention Can you help me for the driving CS5532ASZ? please send me c code for driving this A/D
  6. G

    [AVR] I have pressing need for the driving CS5532ASZ

    Hi I have pressing need for the driving CS5532ASZ in the AVR microcontroller with SPI interface. Please help me for writhing c code program by considering the following: 1- Sampling frequency is constant (such as 100 HZ) 2- Analog signal is -2.5 to +2.5 volt 3- Used 2 channels of CS5532ASZ for...
  7. G

    [General] Circuit for pulse generation

    HI First,Thank you for your attention AVR microcobtroler using in this project and no problem to use each type of it. please help me for design and generation this waveform
  8. G

    [General] Circuit for pulse generation

    First,Thank you for your attention output voltage can be 0 - 15v and current is 0- 2 A or Any amount that you can design. Output waveform should be Similar to the proposed. X1 and X2 and X3 and start trigger can be Regulated with use keyboard or USB interface (by labview software). If the...
  9. G

    [General] Circuit for pulse generation

    Hi I have pressing need for the following pulse: The Square Wave specifications are as follows: The pulse consists of: ON(Positive voltage)- OFF- ON(Negative voltage)- OFF ......... T(ON)= T(OFF) X1= 0.25 S – 8 S X2= Number of cycles = 2- 4- 6- 8- 10 X3= output voltage In this circuit output...
See more

Part and Inventory Search

Back
Top