Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I tried to post image, but I have a message saying Admin needs to approve...
- - - Updated - - -
No, not at all. I am interfacing to ABS signals on a race car. Normally I can interface directly and this works great (because I can bias the signal directly to Gnd), but in this application there...
Hi
I can't interfere with the signal. So diodes / clamps etc are a no no unless I can use 100kR resistors in series with the two input lines...
Here is a signal conditioning circuit that works on the sim but not in practice.
Interestingly I accidentally swapped the inputs on the last OpAmp...
Ok, so I think what I am trying to do should be simple enough with a diff amp...
The signal is not ground biased, so I need to convert it being ground biased.
How do I convert a non-ground biased signal to a ground biased signal?
One way I guess I can do it is by using an ADC with...
Hi
I need help with a relatively simple Analog design problem....
I have a differential signal that I am 'tapping' into. (It goes to another system...so input impedance of my circuit must be high > 100kR).
The characteristics of the signal are:
Amplitude can be 1vpp to 5vpp
Offset is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.