Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Does anybody know of any equipments using Samsungs S3C2410 processor, especially a medical equipment. I know the hp ipaq uses it , anything else.
Any help is appreciated
-firmy
Hi,
I am trying to calculate the maximum power rating of a MCU in mA
The electrical data manual says
Typical VDDi / VDDio = 1.8/3.3 V
Typical normal mode power (Total VDDi + VDDio) = 224 mW
Should I divide 224 with 1.8 or 3.3V to get power in mA?
(The MCU is samsungs S3C2410x)
Please help...
rtos concepts pdf
One major need for an RTOS is if you have to execute multiple threads ...writing a schedular in C to make other threads than the usual main() to run in parallel is made much simpler if you have a real time operating system doing the job for you, and the fact that it is...
BSP contains all the low level drivers for the specific board it was written for. Your work gets much easier with it because you can start right away with your application level code using the functions provided by the BSP to access the hardware ...Well this is just one way to look at it !
-F
Hi
I am just curious to know if logical effort is actually used in the industry design ...its very convincing to read though ...i just finished reading Logical Effort by Harris.......
-F
Re: Which one is better?
according to me I would always vote on analog design as the more challenging one ....well thats another reason you dont get any tom & harry doing analog but there are loads of digital guys around ...by the way I myself am into digital :-)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
