Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi All....
I am working on programming Zigbee microcontrollers, i have implemented many things for RF communications.. Now my aim is to dynamically track the battery health level of each Zigbee node and display these level on LCD attached with Controller board/coordinator. Can anybody tell me...
Jennic Programming is really very easy... the problem with you is that you are confused from where you should start your application programming....
here is a question i would like to ask?
1) Do you have Jennic MCUs or Jennic Evaluation kit i.e. JN5148-EK010?
if you have MCU, then you have to...
Hy All!
I am currently working on PIC Microcontrollers. for testing purpose i used pic18f452. I simply configured port B as output and then set all the bits through PORTB = 0xff; i observed that all the pins are set except the PGM (RB5). can anybody tell me where can be the problem?
i think i can help you out....
please sent me your jennic code at the following e-address, then i will try to fix your problem.
ijazahmad3605@yahoo.com
regards:
Engr. Ijaz Ahmad
Ya, i am sending you some pdf's that will help you programming the jennic 5148:-D
send me your email, i will send you these pdf's.
ijazahmad3605@yahoo.com
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.