Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I am currently willing to design circuits using the Barkley's BSIMSOI model file. I have downloaded the verilog-A code, but during simulation in Cadence, it is asking for the values of the following parameters:
Name
Description
Units
Id
Drain current
amperes
Ig
Gate current...
Why are you so much worried about the version/setup procedure? any installation procedure in linux is easy if you know what u r doing & can become sketchy if u don't know. Anyway, the best thing for u is to install 'wine' first & then u can easily install the windows version of xilinx in ubuntu..
Can you please explain me more about that 'Cgd crosstalk'... I know the transistors consists of several junction capacitances, but I didn't understand that voltage shift.. please explain it a little more..:(
The transistor model 'dual.md'...
This is a simple problem that has been haunting me from a very very long time.
I am explaining it with a simple example of an inverter. Lets see the outputof this simple Spice command:
* Waveform probing commands
.probe
.options probefilename="sedit.dat"
+ probesdbfile="Inverter2.sdb"
+...
Thanks Bigboss!!!!!!!! You solved a great problem!!
Only one thing I would like to mention is that,
the line you mentioned is for the ".bashrc" file. Whenever setting for a ".cshrc" file, the command will be:
"setenv CDS_Netlisting_Mode Analog"
Cheers!:-):-)
---------- Post added at 17:20...
ok, first I have installed Cadence IC5141 Hotfix,ICC11241.. Do I need to install SPB162 or 163?
& Do I need PACIFIC61? I intend to simulate circuits & make layouts.
Initially I installed IC5141, but was unable to configure. I have installed configure utils but I don't know how to use it through...
Following the https://www.edaboard.com/threads/205992/ thread, I have done some advances. Now here is an odd problem I am facing with Cadence IC5141.
I have done a layout of the simple voltage divider circuit using the RNNPO_RF model file in UMC018 library.
Now, It was showing incomplete...
Re: layout xl show incomplete nets
I have also faced a similar problem..Why don't you upload screenshots of your schematic & the corresponding Layout.. It will help me to understand the problem better....
I found one of the members have installed IC5141 in ubuntu 10.04. Have anyone tried installing one in the latest ubuntu 10.10? I am going to give it a try if anyone can help me out on this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.