Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
i have designed a closed loop boost converter circuit using zero voltage switching.(m-type) i have already done from the hardware >
specifications:
input voltage = 30v
output voltage = 75v
frequency = 20khz
duty cycle = 60%
so my question in the result , i don't know with this result...
hi,
I've designed a boost converter with a 30V input. It is running at 60% duty cycle.
for pwm circuit i have been used pic to generate a pwm.
so my question is (as shown in the circuit) hows the pwm inverted (after gate drive)
any help to understand the operation of the gate drive?
i am doing a project of boost converter using zero voltage switching (ZVS), the overall schematic shown in figure below. am using timer 555 to generate PWM to trigger the mosfet, the frequency about 600hz, Vin = 12v, Vo=47.5v, duty cycle = 58%, so my problem is how to calculate the resonant...
hi,
i have designed a boost converter circuit with input voltage 12v, and the other elements as shown in attached figure
so, my problem is the output of this circuit is right (as shown), and also i got the result of the inductor voltage, but am sure its wrong.
any body help me
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
