Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In Turkey,
8051 was the first but nowadays PICs espacially F84 and F877 is the first because their variety and suppliement and cost.
but AVR is coming to be famous.
drill holes in artwork cadstar
My problem is completely same with yours. But i use POWERPCB. By the way i haven't found any information about it.
good luck
hello again.
@ted
thanks for help but my all pads and vias are annular type. i see the drill holes during the design time but they are all filled in PCB PRINTOUTS
Hello everybody.
I have used POWERPCB 5.0.1 and been new on it.
I see everything on the PCB board but i don't see via and pad holes
in PCB printouts. Namely all holes are filled. What should i do to see empty holes in pads and vias?
Thanks a lot for helps
thanks a lot to all
I found my way:
i changed the max-via-count so i succeed.
BUT
when a topic is opened about the best EDA tools, everybody has an idea about them. But when a help is needed everybody is suspend except some friends.
Anyway
thnx
specctra problem
I use Specctra V7.1 for autorouting .
Here are my problems:
For example i use 2 layers. When autorouting finishes i see layer to layer junctions anywhere on board. But i want specctra to autoroute layer to layer jumping only on pins.
2th problem:
Also when i use only one...
crownhill proton suite
It can ve changed according to everone's classical programming choices. For example i love basic routines therefore i like picbasic.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
