Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
someone has pointed me in the direction of these
Sensors, Sensor Conditioning, 4-20mA Transmitter - 4-20mA Conditioning - RCV420 - TI.com
Any ideas on how what other components are needed?
so it isnt as easy as using something like this
**broken link removed**
with something to isolate each sides voltage supply? i.e something like this
**broken link removed**
use the same 24V supply from the PH/CF transmitter and solder the input and output signal wires on?
so they can not be easily made with a couple of components?
---------- Post added at 12:57 ---------- Previous post was at 12:52 ----------
I need to connect the PH/Cf transmitter to the AD inputs of one of these...
PICPLC16 v6 PLC System - PIC Microcontroller Board - mikroElektronika
Well...
Hi all,
I have a combined PH and CF transmitter of which can be found here
pH and Conductivity Transmitter
I need to make 2 x 4 - 20mA loop isolators that I can connect to each output. The unit runs on a 24V power supply
Someone has pointed me to some of the components
**broken link...
Hi all,
I am looking for an experienced code who can work with these
PICPLC16 v6 PLC System - PIC Microcontroller Board - mikroElektronika
I need to join two of these boards together due to the amount of inputs and outputs needed.
The system will have a gsm controller on it and everything...
Thanks for your reply..
I have had a good look at the commands and have tried to understand them to the best of my ability of which is very limited..I bought this bais controller on the basis the Quectel would of already been pre-programmed. I have no idea about how to communicate with it and...
Ive since found it its using a quectel M10..Im asuming there will be a command to raise the message validity?
**broken link removed**
page 104...ive no idea what im doing or if I can even comunicate with the quectel M10
Please point me in right direction
Thanks
Hi all,
I have bought a sample SMS controller from China and have it controlling various of devices just fine...its working great and im very happy with it.
The controller is here
GSM SMS Auto Controller,RTU5011 - Detailed info for GSM SMS Auto Controller,RTU5011,GSM SMS Controller,GSM SMS...
Im now thinking of cutting in 16 x IEC connectors and putting the female plugs on the end of the flex's...a 10+ amp kettle lead is way to big though...I would have to take out the 7 x 20mm flex glands and hopefully the sockets I cut in will cover the wholes...some kind of IEC type kettle lead...
hi all,
I am an electrican (tried 2 x electricians forums) and I have a client who owns a converted church of which has very high ceilings. He has asked me to install a winch system that he can lower the ceiling lights with, change the lamps and raise them up again. I have looked at various...
hi all,
I am making a project of which has a 400mm x 400mm x 100mm adaptable box that has 16 cables going into it of which are 0.5mm 2 core or 0.75mm 3 core...the 3 core flex's are 230V mains cables with a max load of 5 amps. Im looking to redesign the whole thing so it can be unassembled...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
