Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by bkat

  1. B

    diode in CMOS technology

    **broken link removed** or razavi's Design of analog cmos integrated circuits make help
  2. B

    need a documentation about bandgap reference

    https://www.google.cn/search?complete=1&hl=zh-CN&newwindow=1&q=bandgap+reference+site%3Aedu&meta= good luck
  3. B

    ELECTRONICS CIRCUITS SIMULATED USING PSPICE

    opamp design sansen's book good luck
  4. B

    Reference Voltages in ADC

    Message is unavailable.
  5. B

    Looking for resources on designing a LVDS buffer

    LVDS buffers you can download some usefull patents form google https://www.google.com/patents
  6. B

    How to design a low supply voltage bandgap that works under the 1.5V supply voltage?

    bandgap find in the ieee with key word "bandgap" "low voltage"
  7. B

    Need info about 1.8 -->15.5 and 15.5-->1.8 levelshift design

    levelshift design https://www.google.com/patents goodluck
  8. B

    Ring Oscillator using SCL ?

    vdd vdd 0 0 100ns 3v as EX. u can add this command to your netlist and try again.
  9. B

    how to desing a 8bit-counter

    you can use verilog or verilog-ASM for mixed signal simulation.
  10. B

    does this constant voltage reference work properly?

    can you tell me how this circuit work? And how the output voltage can be constant?
  11. B

    How to determonie the opa specs for bandgap reference?

    PSRR -- > GAIN AND BW accuracy of the VBGR --> Input offset voltage stablity --> BW just guess
  12. B

    about Bandgap op connect problem

    I agree about that you should analysis the small signal model for more information.
  13. B

    [help]How to design this BGR

    Sorry ! You are right, is my mistake Thank you ! Added after 1 minutes: Sorry ! You are right, is my mistake. the current Independent of PV. Thank you !
  14. B

    [help]How to design this BGR

    no need the start up circuit and the voltage range : 2v ~ 6v bkat
  15. B

    [help]How to design this BGR

    to szekit Thanks you for hlep. off course the diode-connected will decrease the gain.but the diode-connected make the bias current of the opamp independent of PVT Do you have any advice about the error amplifier? thanks
See more

Part and Inventory Search

Back
Top