Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank-you for your early reply. I need to be able to update the EEPROM from PC. Your reply helps me a lot.
I can now go ahead only with the PIC and not include the MCP2221, as a playground, in the worst case.
Thanks again!!
Hello,
I intend to use the PIC 18F67J50 in my project with the CDC class libraries to interface the native USB to a PC using PC USB port.
I have an I2C EEPROM connected to the uC.
Is it possible to update the contents of the EEPROM from the PC and avoid using a USB I2C bridge like MCP2221...
Take a look at LMP90100 from TI. It will serve the need you have.
Remember to allow sufficient settling time after you switch the channels.
I hope that this helps.
Thank-you Walt!
I am designing a generic audio interface. Three LEARN buttons will LEARN (Vol-up, Vol-dn, Mute) IR codes from remotes and store it against the respective functions. In the play mode, The remote will be able to control the volume and mute.
I will be using 18F67K22. TSMP7700 is on...
Hello hexreader,
Thank you for your codes on IR so far, posted on mikroE.
Do you think you have time to make a universal IR receiver? That would be cool and could replace all existing versions. It could be based on the TSMP58000 IC from Vishay.
Thanks in advance!!
bimbla.
Hello,
Kindly refer to the datasheet of TDA7293. The concept of bridging and paralleling are explained. If you have any further doubts there after, we can discuss it here.
I hope that this helps.
single supply pwm dac output
Hello,
Make sure to pass the DAC output through a low pass filter, preferably a 2nd order, to remove the traces of switching frequency.
Regards,
bimbla.
Median value select
Hello,
In analog circuit/ domain, is there a way to output the median value of three variables?
It becomes easy using microcontrollers, but i would like to know if it can be done using only analog circuit (discrete devices, op-amps etc.)
Thanks in advance,
Regards,
bimbla.
Hello,
Not very many from India migrate to the US from the hardware domain.
What is he situation there like?
Are many jobs available for Analog Hardware designers?
Regards,
bimbla.
class d amplifier motor controll
Hello,
Instead of Sine wave audio input, can I use dc coupling and give a dc voltage input to use the Class-D audio amplifier as a speed controller for DC motor (bi-directional)
Thanks and regards,
bimbla.
I just wanted to clarify that PSpice is an OrCAD product.
OrCAD is taken over by Cadence.
So you will find PSpice bundled with OrCAD Capture and Cadence HDL Designer.
Regards,
bimbla.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.